Topic 1 Question 50
A company has an AWS Direct Connect connection between its on-premises data center in the United States (US) and workloads in the us-east-1 Region. The connection uses a transit VIF to connect the data center to a transit gateway in us-east-1. The company is opening a new office in Europe with a new on-premises data center in England. A Direct Connect connection will connect the new data center with some workloads that are running in a single VPC in the eu-west-2 Region. The company needs to connect the US data center and us-east-1 with the Europe data center and eu-west-2. A network engineer must establish full connectivity between the data centers and Regions with the lowest possible latency. How should the network engineer design the network architecture to meet these requirements?
Connect the VPC in eu-west-2 with the Europe data center by using a Direct Connect gateway and a private VIF. Associate the transit gateway in us-east-1 with the same Direct Connect gateway. Enable SiteLink for the transit VIF and the private VIF.
Connect the VPC in eu-west-2 to a new transit gateway. Connect the Europe data center to the new transit gateway by using a Direct Connect gateway and a new transit VIF. Associate the transit gateway in us-east-1 with the same Direct Connect gateway. Enable SiteLink for both transit VIFs. Peer the two transit gateways.
Connect the VPC in eu-west-2 to a new transit gateway. Connect the Europe data center to the new transit gateway by using a Direct Connect gateway and a new transit VIF. Create a new Direct Connect gateway. Associate the transit gateway in us-east-1 with the new Direct Connect gateway. Enable SiteLink for both transit VIFs. Peer the two transit gateways.
Connect the VPC in eu-west-2 with the Europe data center by using a Direct Connect gateway and a private VIF. Create a new Direct Connect gateway. Associate the transit gateway in us-east-1 with the new Direct Connect gateway. Enable SiteLink for the transit VIF and the private VIF.
ユーザの投票
コメント(5)
B) is correct. Below link (Figure 9) explains.
👍 6study_aws12023/03/22B - correct.
This solution creates a new transit gateway in the eu-west-2 Region and connects it to the VPC in that Region. The Europe data center is connected to the new transit gateway using a Direct Connect gateway and a new transit VIF. The transit gateway in us-east-1 is associated with the same Direct Connect gateway, and both transit VIFs are enabled with SiteLink. The two transit gateways are then peered, allowing full connectivity between the data centers and Regions with the lowest possible latency. This solution is cost-effective and efficient as it does not require creating a new Direct Connect gateway.
👍 3zaazanuna2023/03/18- 正解だと思う選択肢: B
I think C is also doable even the SiteLink part won't help. But the traffic can go around via the Transit Gateway peering. However, C costs you more money and it gets higher latency than B. The answer is B.
👍 3rhinozD2023/04/28
シャッフルモード